User's Manual

9
Repeat the current track
• Press the REPEAT button until “ rP1 ” blinks on the display. The
current track will be played repeatedly.
Repeat the Entire CD
• Press the REPEAT button until “ rPA ” stops blinking and remains
on. All tracks will be played repeatedly.
Cancel Playback Mode
• Press the REPEAT button to cancel the playing until “ OFF ”
appears.
Random Playback
Random Playback
• Press the RANDOM button on the remote control and “ rdn ” will
be shown on the display. All tracks will be played randomly. After
all tracks have played, the unit will stop automatically.
Cancel Random Playback
• Press the RANDOM button on the remote control again during
RANDOM playback to return to normal playback and “ OFF ” will
be shown on the display.
Repeat Playback
Troubleshooting Guide
No power.
• System does not turn on.
• Make sure AC power plug is secure in the outlet, and outlet has
power.
The remote control does not function.
• Make sure the infrared remote sensor is not blocked.
• Point the remote directly at the infrared remote sensor on the
unit.
• Replace the battery in the remote control with a new one.
Poor FM reception.
• Make sure FM antenna wire is fully extended.
• Electrical interference in your home can cause poor reception.
Move the unit away from them (especially those with motors and
transformers).
The CD Disc does not play.
• Make sure you’ve selected CD mode.
• Make sure disc label is facing up.
• Make sure disc is clean.
• Pause mode is activated.
• Disc may be damaged or dirty; check disc.
Severe hum or noise is heard.
• The plugs and jacks are dirty. Wipe them with a cloth slightly
moistened with alcohol.
• Clean the disc.
Cleaning the Disc
A defective or soiled disc inserted into the unit can cause sound to
drop out during playback.
Handle the disc by holding its inner and outer edges.
• Do NOT touch the surface of the unlabeled side of the disc.
• Do NOT stick paper or tape on the surface.
• Do NOT expose the disc to direct sunlight or
excessive heat.
• Clean the disc before playback. Wipe the disc
from the center outward with a cleaning cloth.
• NEVER use solvents such as benzine or alcohol to clean the disc.
• Do NOT use irregular shaped discs (example: heart shaped,
octagonal, etc.). They may cause malfunctions.
Cleaning the Unit
• Be sure to turn the unit off and disconnect the AC power adapter
before cleaning the unit.
• Wipe the unit with a dry soft cloth. If the surfaces are extremely
dirty, wipe clean with a cloth that has been dipped in a weak
soap-and-water solution and wrung out thoroughly, then wipe
with a dry cloth.
• Never use alcohol, benzine, thinner, cleaning fluid or other
chemicals. Do NOT use compressed air to remove dust.
Important Note
• Before transporting the unit, remove the disc from the disc
compartment.
Maintenance
EN