User's Manual

5
EN
Before Bluetooth pairing, you should turn on the
Bluetooth function of your other device (such as,
mobile phone with Bluetooth function).
1.PressSOURCEbuttonontheunitor
button on
the remote control to select BT (Bluetooth) mode.
The Bluetooth indicator light on the soundbase
will blink.
2.Onyourdevice(mobilephone,MP3player,etc.),
select RCA RTS7010B from thelist of available
Bluetooth connections.
Note: If your Bluetooth device (such as, mobile
phone) requires a password while pairing, please
enter4-digitnumber:0000.
• If the Bluetooth pairing is successful, the
Bluetooth indicator will illuminate.
• If the Bluetooth pairing is unsuccessful, the
Bluetooth indicator will blink at slow speed.
Please try again.
TO DISCONNECT THE CURRENTLY PAIRED
DEVICE
1. On your currently paired and connected device,
selectRCARTS7010Bfromthelistanddisconnect
it. Or
2. Turn off the connected device.
ENJOY THE MUSIC THROUGH BLUETOOTH
• Press to begin or pause playback
• Press
/ to select a specific track
• Press and hold 
 / to start moving
backward/forwardathighspeed.
BLUETOOTH PAIRING BASIC OPERATION
1. Press  button on the Soundbase or
button on the remote to turn on the unit.
2. PressSOURCE
/ on the remote to select
AUXIN,OPTICALIN,LINEINorBluetoothsource
(input).TheLEDslocatedontopofSoundbase
will indicate the currently-selected source.
3. Press VOLUME
 /  , BASS  / or
TREBLE
/ ontheremotetoadjustVolume,
Bass or Treble levels. When adjusting Volume,
Bass or Treble, the four LEDs will temporarily
display the current level setting (see illustration).
Note:Whenmuteisenabled,the4LEDindicators
will ash. Press the MUTE button on the remote
controltodisablethemutefunctionandLEDashing
stop.
Specicationsandexternalappearancearesubjecttochangewithoutnotice.
TROUBLESHOOTING
The unit does not switch on.
• Makesureitispluggedin.
• Press STANDBY/ON button to turn on the
Soundbase.
I have no sound.
• PresstheVOLUME
/ button on the top of
the Soundbase or VOL
 / button on the
remote.
• Ensure the source you’ve selected is outputting
audio.Ifyou’reusing“audioout”fromyourTV,
ensureyourTVisconguredtooutputaudio(see
TV’smenusettings).
• Ensure your AV connections are properly made
(ensure you don’t have any loose connections).
• Ensureyou’veselectedthecorrectsource(input)
-theLEDslocatedonthetopoftheSoundbase
will indicate the currently-selected source (input).
• Mute is activated (the 4 LEDs on top of the
Soundbaseashes).Pressthemutebuttononthe
remote control.
• EnsuretheinputsourceisselectedPCMoutputon
the setup menu of the input device.
Cannot setup Bluetooth pairing
• Resetthebluetoothconnectionbyturningoffand
onyourconnectinddevice,orthisSoundbase,or
selectotherSOURCEonthisSoundbasethenback
to BT mode again.
The remote control doesn’t work
• Ifbatteryisweak,pleasereplacethebatteryand
ensure the new battery is installed correctly.
• Pleaseensurethereisnothingblockingtheremote
sensoronthefrontoftheSoundbase.