Quick Reference Guide

SCRAM CAM
Quick Reference Guide
28
2) Click the Communication sub-tab.
3) Verify by looking at the current top Date/Time link
that SCRAM
NET has received bracelet readings.
4) Open the communication and verify that a “Initial
Baseline Reading Taken” message appears.
d. Wake up the bracelet to ensure that the pump runs.
e. Insert the tamper clips into the buckle slots and squeeze
together until you hear a distinct click.
PERFORM MANUAL DATA UPLOAD
1. Log into the Direct Connect application.
a. Open the Direct Connect application.
b. Log into the Direct Connect application using your SCRAM
NET
username and password.
2. Connect the Direct Connect device with the Direct Connect
application.
a. Plug the small (mini-B type) USB connector into the Direct
Connect device.
b. Plug the large (A type) USB connector into a USB port on
your computer.
The
red and blue lights on the Direct Connect device blink
for approximately 5 seconds then remain on.
Bracelet status in the Direct Connect application: Waiting for
Bracelet
3. Attach the Direct Connect device to the bracelet.
a. Align the Direct Connect device with the top of the bracelet.
b. Slide the Direct Connect device down over the bracelet.
4. Wake up the bracelet.
a. Momentarily place the magnet on the Direct Connect device
where the word Magnet appears.
At this time:
» Bracelet status in the Direct Connect application:
Communicating
» On the Direct Connect device, the
red light turns off
while the
blue light remains on.
» Any remaining data is transferred from the bracelet to
SCRAM
NET.
» The bracelet software is checked and updated, if
necessary.
When complete:
» The
blue light turns off for approximately 5 seconds
then both lights turn back on.
» Bracelet status in the Direct Connect application:
Communication Complete
Note: After 10 seconds, the status changes to: Waiting