Instruction manual

IMPORTANT

Only use the mains power adaptors and telephone line cord supplied with the

product.

4. Setting up the telephone base and handset

- Telephone base

1. Plug the handset, mains power adaptor (the power adaptor for the

telephone base has a small clear plastic plug at one end) and telephone

cable into the clearly marked sockets on the underside of the telephone

base.

2. Push the metal stand into the two holes underneath the two rubber feet at the

back of the product. Make sure the metal stand is pushed firmly into place.

3. Plug the power adaptor into the mains wall socket and switch the power on.

- Cordless handset

1. Plug the mains power adaptor into the power socket on the underside of

the charger (the power adaptor for the charger has a small red plastic plug

at one end) and plug the other end into the mains power wall socket and

switch on.

2. Remove the battery cover from the back of the handset and insert the 2 x

AAA rechargeable batteries supplied. Please note the ‘+’ and ‘-’ markings

inside the battery compartment and insert the batteries the correct way

round. Slide the battery compartment shut.

WARNING

Use only approved rechargeable batteries supplied with your ALCOM

Premium Colombo Combo. Please do not use alkaline or non-rechargeable

batteries. It may cause permanent damage to the product and void the

warranty.

3. Place the handset onto the base to charge for at least 24 hours. When the

handset is fully charged the battery icon in the top right of the display will

indicate this.

4. After 24 hours, plug the telephone line cord from the telephone base into

the telephone wall socket.