User guide



The outside call is put on hold. When the other handset answers, you can

speak to the user. If the other handset does not answer, you can get back to

the outside call by pressing

"INTERCOM"

again, or you will automatically

be reconnected to the outside call after 30 seconds.

When the other handset answers your intercom, press

"HANG UP"

To set up a three-way conference between two

handsets and an outside call

Set up a three-way conference call

Either make or answer an outside call with one handset(e.g HS1),

1).

2).

Press

"INTERCOM"

,then key in the number of another handset (or key "0" for

To register a handset to a new base:

The handset(s) supplied with your CC2300 system are already registered

— the first one as handset number 1, the second as number 2...etc

You don’t need to re-register them, unless you have a problem.

To check whether a handset is registered, make sure mains power to the base

unit is switched on and the handset is within range. The handset’s display

should show its number, and the ‘signal level’ symbol on the display should

show three bars. If the display shows

"UNREGISTERED"

, you need to re-register the

handset using the following process:

10.Handset registration

to transfer the outside call to the other handset, and to hang up your handset.

You can also transfer the call without waiting for the other handset to answer.

Press followed by the number of the handset you want to

transfer the call to, and then press The other handset will

then ring, but if it is not answered within 1 minute, all handsets will ring for a

further minute, and if none answer by then the outside call will be disconnected.

"HANG UP"

"INTERCOM"

(or one handset, the base and an outside call):

the base and the outside call will be put on hold.

When the other handset (or the base) answers the call, press the STAR button

on the handset (HS1) to connect the three parties together.

To end the conference call either handset (or base) can "HANG UP"

4).

and the other handset will be left connected to the outside call.

3).