User guide

“ My call was cut off
when I went out of
range. Now I can't
use my handset.
Move the handset closer
to the base unit before you try again to make a call.
Move the handset closer to the base unit, or to a different position.
“ There is
interference and
noise on the line”
Try moving the base unit so that it is
not near other electrical equipment
such as a television or a computer.
You’ ll get the best sound if you place the base unit
as high as possible
.
For example, in a two-storey house, the first-floor landing is an ideal place.
You may be going
out of range
of the base unit. Move closer or your call
may be cut off.
“ I hear ‘ from
my handset while
I’ m on a call”
Check the
Battery Level
on display. If it is low, recharge the
batteries.
You need to subscribe
to the Caller Display feature from your network
service provider.
“ The Caller Display
feature isn't
working”
Or they may
“ When I try to make
a call, I hear Busy
tone.”
If you are usinga CC2300 multi-handset system, check that other handset
are not already on a call.
Make sure you’ re holding the earpiece correctly over your ear.
“ The volume in the
earpiece is low when
”
Adjust the volume using the UP/DOWN button.
Intercom and transfer
Make sure the other handset is in range of the base unit.
“ I can
call”
Make sure you are dialling the correct number for the other handset.
Batteries
“ The handset is not
functioning even
after charging for
Remove the batteries from the handset and wait for a few seconds before
replacing them. If the problem persists, replace the batteries.
Before you first use the handset, you should have left it on the base unit
15 hours to charge the batteries fully.
You may need to replace he batteries
“ The handset ’ s
battery pack is
running low within
an hour or two”
Check the connection between the base unit and the mains power socket
You need to replace the batteries. To find out how to obtain replacements
call the on
“ I try to recharge
”
Dispose of used batteries safely – never burn them, or put them where
Do not use non
-
rechargeable batteries in your CC2300
–
they may
burst, causing damage.
If the fault persists…
•
Disconnect all other instruments connected to the same line as the
26
'beeps'
I'm on a call
't transfer a
t
or charger pod for
they could get punctured.
(e.g.it may) be an international call.)
transmit the caller 's number
15 hours”
the batteries but I
still get a warning
that they are low
ALCOM helpline (65) 6841 2668.
be calling from a network that does not
CC2300 and try to make a call.