User's Manual Part 5

4.2 8065751025

Constellation

Vision System

UPON COMPLETION OF THE PROCEDURE

STEP ONE: Clean handpieces, probes, cables, forceps, etc., as instructed in DFU's

supplied with each accessory.

STEP TWO: Remove irrigation bottle from hanger and set aside. Remove spike from

irrigation bottle and discard tubing.

STEP THREE: Eject cassette and discard.

STEP FOUR: Flip the irrigation bottle holder to its storage position.

STEP FIVE: Press Standby power switch located at top of rear panel to remove

operating power from the system.

STEP SIX: Turn the Main power switch OFF. It is located in the middle of the rear

panel above the power cord.

STEP SEVEN: Remove air hose. Turn off C3F8 and SF6 valves.

STEP SEVEN: Disconnect the power cable from the wall receptacle and wind the

cable around the cord wrap.

STEP EIGHT: Place the footswitch and cable in storage compartment in front of base.

STEP NINE: If required, the front panel, the console, the footswitch, and the remote

control may be wiped with non-corrosive germicidal solution, alcohol, or mild soap

and water.

CAUTIONS

• Do not clean console or accessories using solvents or abrasives.

• Avoid spilling

BSS

solution, or moisture of any kind, around the electrical

handpiece connectors.