Operation Manual

10
PROGRAMMING A NEW HANDSET INTO THE SYSTEM
Setting your handset unit representative number on the Base unit. First, set the POWER switch
of the Base and Handset unit to off.
BASE UNIT
1. Press SEL and without releasing POWER on the Base
Unit.
2. All the LED indicators will be displayed and also
Indicator NO. 1.
3. Press SEL to change to the Remote Unit No. that you
wish to represent either “2”, “3” and “4”.
4. Press the INT button.
NOTE
Once you press the INT button, you must complete the following procedures within 5 seconds
to successfully complete the procedure.
HANDSET
5. Press MEMO and ^ simultaneously, and set the POWER
switch to ON. The programming procedures are
successful when hearing 5 “di” sounds.
6. Set the POWER switch to the OFF position and switch it
to ON again.
7. Press CALL to see if the handset number indicator that
flashes is the handset that you just programmed.
NOTE
If you make a mistake when following the programming
procedures, repeat the above four steps again.
1
3
2
4
1
2
1
2
OFF ON