Manualshelf

User`s guide

ManualsBrandsAlcorn Mcbride ManualsGadgets8 TraXX
11121314151617181920
Page 16 January 8, 2014 • Alcorn McBride ProTraXX User’s Manual • Rev 1.7
Factory Defaults
(DIP 4)
Activating this switch returns the unit to its default (factory) state. These defaults
are listed below.
Factory Defaults
Parameter Default Value
IP Address 192.168.0.254
Subnet Mask 255.255.255.0
Gateway 192.168.0.1
Nameserver (DNS) 127.0.0.1
NTP Server pool.ntp.org
FTP User admin
FTP Password password
UDP Port 2638
RS232 Serial
9600 Baud, 8 Data Bits, No Parity, 1 Stop
Bit
Buttons Enabled Yes
LCD PIN 1111
LCD Locked No
Master Volume 100
Legacy Mode No
NTP No
Spot Logging No
Timezone Offset 0
Daylight Savings Mode None
Control Inputs Mode Contact Closure
Phantom Power DIP Switch
Setting this DIP switch to the ON position enables phantom power (48V) on
the microphone input.
Phantom power is on when the switch is up. In this photo, phantom power
is turned off.