User`s manual

Alcorn McBride Binloop User’s Manual Page 29
Get/Set SMPTE Start time
Description: This command will get or set the SMPTE start time.
Parameters: hh = hours
mm = minutes
ss = seconds
ff = frames
Get Command: RT
Response: hh:mm:ss.ff
Example: Command: RT
Response: 00:00:01.00
Set Command: hh:mm:ss.ffRT
Response: R
Example: Command: 00:00:01.00RT
Response: R
Get/Set SMPTE End time
Description: This command will get or set the SMPTE end time.
Parameters: hh = hours
mm = minutes
ss = seconds
ff = frames
Get Command: ET
Response: hh:mm:ss.ff
Example: Command: ET
Response: 01:00:00.00
Set Command: hh:mm:ss.ffET
Response: R
Example: Command: 01:00:00.00ET
Response: R