User`s guide

Installing the Input Expander 3
Installation
Installing the Input Expander
There are two ways to install the Input Expander. On a DIN Rail, thus the
exciting orange casing or on a wall.
DIN Rail Mounting
The Input expander has two DIN Rail clips for mounting to a
standard DIN Rail. Shown is a side view of the assembled card.
Just set one clip edge on the top of the DIN Rail and rotate in
the board until you hear the other piece click into place.
Wall Mounting
Upon removing the orange DIN Rail
casing by unsnapping the end caps and
sliding out the circuit board, you’ll find
four screw holes are available for
mounting to a non-conducting surface.