User`s guide

Page 26 May 15, 2012 • Alcorn McBride TourTraXX User’s Manual • Rev 1.3

Add/Edit Event

Now for the fun part! Click on Add to add a trigger event to one of the

inputs, buttons, or input groups. The Add/Edit Event window will appear.

The best way to make the TourTraXX to play a file on startup is to select the

Device Powered On Trigger Type.

Once you have chosen where the event is being triggered from, you can select either

an Active On or Active Off Trigger Edge. This allows the TourTraXX to respond to

either normally-open or normally-closed input sources.

In the Event field you specify exactly what action you want the Event to

perform. You can have it play a file or you can specify a Custom Command,

where you can use any command out of the Command Reference in this

manual.

The Configuration File

is named

“CONFIG.LST” which

the TourTraXX always

loads on startup.

Click Add once you’ve finished making your choices and the trigger will be added

to the TourTraXX configuration file.

Now you need to save your file. To do this select Save Configuration and choose

the TourTraXX you want to send this configuration to. If you don’t have access to

the TourTraXX at the time, you can also save the configuration to your hard drive

and then later copy it to the TourTraXX Compact Flash and insert it into the unit.

Select One of the 8 Rear Inputs

(note: any inputs previously assigned to Input

Groups will not appear in the list)

Select One of the Input Groups

(if any are assigned)

Select “Device Powered On” to make event

happen on bootup.