User`s guide

Page 52 May 15, 2012 • Alcorn McBride TourTraXX User’s Manual • Rev 1.3
Aux Input to Channels
Description: This command will route the audio being received on the TourTraXX’s auxiliary
inputs to the specified channel, channel pair, or channel group.
Command Bytes: CL<d>PL
Parameters: <d> is either C followed by a channel number in ASCII, P followed by a channel
pair number in ASCII, or G followed by a channel group number in ASCII
Comments: Channel numbers range from 1 through 16, Channel Pairs from 1 through 8, and
Channel Groups from 1 through 13. Use “*” for All Channels.
Message Response: R
Examples: Route Aux Input to Channel Pair 2. CLP2PL
Route Aux Input to Channel Group 4. CLG4PL
Route Aux Input to All Channels. CL*PL
Add Channels to Channel Group
Description: This command will create a group from the specified channels. This allows you to
control the grouped channels as one.
Command Bytes: A<n>C<#,#,#>GR
Parameters: <n> is the channel group number(1-16)
<#,#,#> are the channels to be added to the group, separated by commas. (up to 16)
Comments: To clear the group, issue the command with no channels listed after C
Message Response: R
Examples: Add channels 2,3,6 to Group 3. A3C2,3,6GR
Clear group 6. A6CGR