User`s guide

Page 54 May 15, 2012 • Alcorn McBride TourTraXX User’s Manual • Rev 1.3
Paging Commands
Set Paging Zone
Description: This command sets the channel, channel pair, or channel group that the microphone
is routed to when the paging trigger is activated or a start paging command is
received.
Command Bytes: Z<d>ZN
Parameters: <d> is either C followed by a channel number in ASCII, P followed by a channel
pair number in ASCII, or G followed by a channel group number in ASCII
Comments: Channel numbers range from 1 through 16, Channel Pairs from 1 through 8, and
Channel Groups from 1 through 13. Use “*” for All Channels.
Minimum OS Version: TraXXOS 1.2.4
Message Response: R
Examples: Set the paging zone to Channel 3. ZC3ZN
Set the paging zone to Channel Group 2. ZG2ZN
Set Paging Trigger
Description: This command specifies which input, front panel button, or push-to-talk will trigger
the microphone to be routed to the set paging zone. Microphone paging will end
when the paging trigger is released.
Command Bytes: T<t><#>ZN
Parameters: <t> is one of the following (in ASCII):
I - Input
K - Mic Push-To-Talk Switch
<#> is the number of the Input
Comments: If specifying the microphone PTT as the trigger, no <#> field is needed. Input
numbers range from 1 to 8.
Minimum OS Version: TraXXOS 1.2.4
Message Response: R
Examples: Set the microphone PTT button to be the paging trigger. TKZN
Set rear input #3 to be the paging trigger. TI3ZN