Club Chair Caution: You must read this before you proceed.
Part NO.
Label Picture Description QTY a Bolt M8X70 5 b Allen Key 1 c Flat Washer Rings 5 d Spring Washer Ring 5 e Plastic Washer Rings 7 Before Beginning Assembly: Page 3 OF 7
Step 1 组装步骤线条图 Position Chair Seat on its back, as shown. DO NOT place on surface that can scratch or damage upholstery. Unzip to open and remove the 4 wooden legs. Step 2 Put the Chair backrest( A) onto a flat table or panel,Insert the Chair seat(B) into Chair Backrest (A) as denoted above. Step 3 You should first fix the middle bolts on the Chair seat (B) tightly until there is no gap between Chair seat (B) and Chair backrest (A).
Step 4 Use Washer Ring to achieve stability Install the leg into the chair by putting a Plastic Washer Ring(e) (improves tightness and security of leg)on the threaded stem. The use of plastic washer rings are OPTIONAL and is especially useful to help alleviate slight wobbliness. Then insert the threaded stem into the threaded hole at each corner of the bottom of the chair. Tighten by turning leg clockwise. Repeat the same procedure to install the other three remaining legs.
Step 5 Turn the chair to its upright position.Then put the Cushions(C)on the Chair seat (B) as shown. Step 6 Make sure all parts are connected and securely locked into position. Your chair is ready for use.
Page 7 OF 7