Installation & Assembly

ManualsBrandsAlcott Hill ManualsCeiling LightsIrwin 3 - Light Kitchen Island Linear Pendant

ASSEMBLING & INSTALLATION INSTRUCTIONS

The drawing shown may not exactly match the product enclosed. However, the

installation instructions do apply to this product.

 WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER.

 ATTENTION! COUPER LE COURANT AU FUSIBLE OU UN DISJONCTEUR.

ASSEMBLING THE FIXTURE (Fig.1)

1. Shut off the power at the circuit breaker box. Remove old fixture and all

hardware from Junction Box. Carefully unpack your new fixture and lay out all

the parts on a clear area. Take care not to lose any small parts necessary for

installation.

2. Slide the electrical wires through the pipe(L)/(K)/(J), ring(I) and canopy(G).

Raise the pipe(L) to top coupling of lamp body(M), by turning it clockwise until

tight. Raise the pipe(K)/(J) and ring(I) onto the end of pipe(L), by turning it

clockwise until tight.

3. Attach the canopy(G) onto the pipe nipple of the pipe(J) and lock it securely

with the lock washer and hex nuts(F).

4. End of pipe nipple screw(C) into single bar (D), place lock washer (B) over end

of nipple protruding through single bar and lock it securely with the hex nut

(A). Take this single bar assembly to junction box with junction box screws (E),

tighten screws securely with screwdriver. The side of the single bar marked

"GND" must face to out. The junction box is not included.

5. While holding the fixture body towards the ceiling, connect the electrical wires

as Shown in Fig.2, making sure that all wire nuts are secured. You may have

to wrap the connections with electrical tape. If your outlet has a ground wire

(green or bare copper), connect the fixture ground wire to it. Otherwise

connect fixture’s ground wire directly to the Single bar with the green screw

provided. After wires are connected, tuck them carefully inside the Junction

Box.

6. Raise the fixture body on to the Junction box, aligning screws on single bar

with mounting hole in canopy and lock it securely with the finial (H). Attach the

glass(N) to the lamp holder and lock it securely with the check ring(O).

7. Install the light bulbs(Not included) in accordance with the fixture’s

specifications. NOTE: DO NOT EXCEED THE SPECIFIED WATTAGE!

Your installation is now complete. Return power to the junction

box and test the fixture.

FIXTURE

WIRES

Black or

Smooth

HOUSE

WIRES

Black(Hot)

FIXTURE

WIRES

White or

Ribbed

FIXTURE

WIRES

Bare

Copper

(Ground)

HOUSE

WIRES

White

(Neutral)

HOUSE

WIRES

Green or Bare

Copper(Ground)

FIG.2

Summary of content (1 pages)

PAGE 1
ASSEMBLING & INSTALLATION INSTRUCTIONS The drawing shown may not exactly match the product enclosed. However, the installation instructions do apply to this product.   WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER. ATTENTION! COUPER LE COURANT AU FUSIBLE OU UN DISJONCTEUR. ASSEMBLING THE FIXTURE (Fig.1) 1. Shut off the power at the circuit breaker box. Remove old fixture and all hardware from Junction Box. Carefully unpack your new fixture and lay out all the parts on a clear area.