Instructions & Assembly

ManualsBrandsAlcott Hill ManualsCeiling LightsIrwin 3 - Light Kitchen Island Linear Pendant

WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER .

ASSEMBLING

ASSEMBLING THE

THE

THE FIXTURE

FIXTURE

FIXTURE (

(

( Fig.

Fig.

Fig. 1

1 )

)

1. Shut off the power at the circuit breaker box. Remove old fixture

and all hardware from Junction Box.

2. Carefully unpack your new fixture and lay out all the parts on a

clear area. Take care not to lose any small parts necessary for

installation.

3. Attach the tube (K) to the coupling of the fixture body(L) , attach

the tube (J) and (I) onto the pipe nipple of the tube (K), by turning

it clockwise until tight.

4. Attach the ring(Q),plate(P), canopy(G) onto the pipe nipple of the

tube (I) , and lock them securely with the washer and hex nuts(F).

5. End of pipe nipple screw into single bar (D), place lock washer (C)

over end of nipple protruding through single bar and lock it

securely with the hex nut (A). Take this single bar assembly to

junction box with junction box screws (E), tighten screws securely

with screwdriver . The side of the single bar marked "GND" must

face to out.

6. While holding the fixture lamp towards the ceiling , connect the

electrical wires as Shown in Fig.2, making sure that all wire nuts

are secured. You may have to wrap the connections with electrical

tape. If your outlet has a ground wire (green or bare copper),

connect the fixture ground wire to it. Otherwise connect fixture ’ s

ground wire directly to the Single bar with the green screw

provided. After wires are connected, tuck them carefully inside the

Junction Box.

7. Raise the fixture body on to the Junction box, aligning screws on

single bar with mounting hole in canopy and lock it securely with

the finial (H) . Attach the glass(M) to the socket holder and lock it

securely with the check ring(N).

8 . Install the light bulbs in accordance with the fixture ’ s specifications.

NOTE:

NOTE: DO

DO NOT

NOT

NOT EXCEED

EXCEED

EXCEED THE

THE

THE SPECIFIED

SPECIFIED

SPECIFIED WATTAGE.

WATTAGE.

Your

Your installation

installation

installation is

is now

now

now complete

complete

complete Return

Return

Return power

power

power to

to the

the

junction

junction box

box

box and

and

and test

test

test the

the

the fixture.

fixture.

Fig.1

Fig. 2

White or

HOUSE

Black

WIRES

(Hot)

Smooth

FIXTURE

WIRES

Black or

Ribbed

WIRES

FIXTURE

Bare Copper(Ground)

FIXTURE

WIRES

Copper

(Ground)

HOUSE

(Neutral)

WIRES

White

Bare

Green or

WIRES

HOUSE

Listed

ASSEMBLING&INSTALLATIONINSTRUCTIONS