Instructions & Assembly
WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER .
MOUNTING
MOUNTING
MOUNTING
MOUNTING THE
THE
THE
THE FIXTURE
FIXTURE
FIXTURE
FIXTURE (Fig.1)
(Fig.1)
(Fig.1)
(Fig.1)
1. Shut off the power at the circuit breaker box. Remove old
fixture and all hardware from Junction Box.
2. Carefully unpack your new fixture and lay out all the parts
on a clear area. Take care not to lose any small parts
necessary for installation.
3. Thread the two Mounting screw (A) about 1/4 ” into the
pre-drilled holes in the Mounting plate spaced the same
distance apart as the holes in the canopy (B).
4. Attach the Mounting plate to the Junction Box with the two
Junction Box Screws as shown. The side of the Mounting
plate marked " GND " must face out.
5. While holding the canopy assembly towards the ceiling,
connect the electrical wires as Shown in Fig.2, making
sure that all wire nuts are secured.
You
may have to wrap
the connections with electrical tape. If your outlet has a
ground wire (green or bare copper) , connect the fixture
ground wire to it . Otherwise connect fixture
’
s ground wire
directly to the Mounting plate with the green screw
provided. After wires are connected, tuck them carefully
inside the Junction Box.
6.
6.
6.
6. R aise the canopy assembly onto the junction box, aligning
screws on mounting plate with mounting holes in canopy
and lock it securely with the ball nut (C).
7.
7.
7.
7. Install the light bulbs in accordance with the fixture
’
s
specifications. NOTE:
NOTE:
NOTE:
NOTE: DO
DO
DO
DO NOT
NOT
NOT
NOT EXCEED
EXCEED
EXCEED
EXCEED THE
THE
THE
THE
SPECIFIED
SPECIFIED
SPECIFIED
SPECIFIED
WATTAGE.
WATTAGE.
WATTAGE.
WATTAGE.
8 . Thread the pipe nipple ( D ) into bottom center coupling of
the socket and lock it securely with the hex nut . Raise the
cover (F), glass shade ( E) and cover ( G ) to the bottom n ipple
of the canopy (B) , using the hex nut ( H ) by turning it
clockwise until tigh t and lock it with the finial (I).
Your
Your
Your
Your
installation
installation
installation
installation is
is
is
is now
now
now
now complete.
complete.
complete.
complete. Return
Return
Return
Return power
power
power
power to
to
to
to the
the
the
the
junction
junction
junction
junction box
box
box
box and
and
and
and test
test
test
test the
the
the
the fixture.
fixture.
fixture.
fixture.
Fig.1
B
Junction Box
Mounting Screw ( A
A
A
A )
Fixture wire
Fixture Ground wire
C
Box screw
Mounting plate
Ground Screw
Supply wire
Supply
Ground wire
Wire nut
D
E
F
G
H
I
Fig. 2
MIN 90 ℃ SUPPLY CONDUCTORS
White or
HOUSE
Black
WIRES
(Hot)
Smooth
FIXTURE
WIRES
Black or
Ribbed
WIRES
FIXTURE
Bare Copper(Ground)
FIXTURE
WIRES
Copper
(Ground)
HOUSE
(Neutral)
WIRES
White
Bare
Green or
WIRES
HOUSE
Listed
U
L
R
ASSEMBLING& INSTALLATIONINSTRUCTIONS
ForCeilingMountFixtures