Installation & Assembly

Assembly Instruction
1. Identify all parts packed in carton against the part list. Remove all protective material
carefully and avoid cutting the surface of the furniture while removing the wrapped
material.
2. Place the base on a non-abrasive, flat surface. Remove the bolts and nuts from the glass
springs at the open end of the rocker mechanism .
3. Align the holes on the support bar, the holes on the plate .Glide the bolts through the
holes. Place the base beneath the support bar. Fasten the flat washers and nuts.
4. Tighten all the bolts and nuts .Test the swivel rocker gently. If the rocker does not rock
properly, double check the assembly procedure.
Parts
Description
Quantity
Parts
Description
Quantity
Chair
Bucket
1
Bolt
4
Base
1
Flat Washer
4
Nut
4
Warning: Do not force components and over tighten the nuts during assembly.