Assembly Instruction

Assembly Instruction
1. Identify all parts packed in carton against the part list. Remove all protective material carefully
and avoid cutting the surface of the furniture while removing the wrapped material.
2. Place the base on a non-abrasive, flat surface. Remove the bolts and nuts from the glass
springs at the open end of the rocker mechanism (See diagram).
3. Note the arrow labels on the rocker mechanism and on the chair support bar. Place the bar on
top of the glass spring and make sure the arrows are pointed at same direction in front of the
chair.
4. Align the holes on the support bar , the holes on the glass springs and the plate keeper. Glide
the bolts through the holes. Place the plate keeper beneath the glass springs and glide the bolts
through the holes on the plate. Fasten the four parts together with flat washers and nuts. (See
diagram).
5. Tighten all the bolts and nuts including the ones at the front part on the rocker mechanism.
Test the swivel rocker gently. If the rocker does not rock properly, double check the assembly
procedure.
Parts
Description
Quantity
Parts
Description
Quantity
Chair
Bucket
1
Bolt
8
Base
1
Flat
Washer
8
Keeper
plate
6
Lock
Washer
8
Nut
8
Warning: Do not force components and over tighten the nuts during assembly.