Operating instructions

FITTED EQUIPMENT
157
FITTED EQUIPMENT
156
Safety precautions:
- Repairs should be carried out only by trained
personnel.
- Inform an approved dealer in case of defects
and malfunctions.
- Before starting off, check the rooflight for
damage in the dome (tension cracks) and the
opening mechanism which could arise owing
to, for example, branches and other natural
causes.
- Do not step on the dome.
- Close the rooflight before starting off (check
whether it is locked).
- Do not leave the vehicle with the rooflight
open (danger of burglary).
- Do not open in strong wind or rain.
- Before opening the dome remove snow, ice,
dirt etc. from the dome.
- Malfunctions are to be repaired by an
approved dealer at once.
- Do not use caustic detergents (danger of
tension cracks in the dome).
- Before setting off close the dome, check the
locking mechansim and open the blinds.
Care instructions:
- Clean the dome with the Seitz Acrylic
Cleaner.
- Opaque spots and light scratches on the
dome can be removed with the Seitz Acrylic
Polish and the Seitz Special Polishing cloth.
- Use talcum powder regularly (4 times yearly)
to care for the rubber seals supplied with
versions without permanent ventilation.
- Clean the blinds only with water and mild
soap suds.
The guarantee becomes null and void if the
care and safety instructions are not followed.
Bessacarr Cameo Models
Heki-2 roof light (Seitz) (Cameo)
The lift/tilt roof light can be set in 3 positions by
means of pneumatic springs.
Position 1 lifts the pane 12mm without allowing
rain to enter the caravan.
Position 2 sets the pane to a 150mm opening
and locks with a bar.
Position 3 opens the pane through 55°.
A fully adjustable flyscreen and black-out
screen are built into the inner frame. The
flyscreen can be drawn independently and the
black-out screen is variable for partial or full
black-out.
Forced ventilation functions via a brush lined
duct instead of a ventilated pane.
A cover hood can be fitted for winter
protection.
Heki-2 roof lights provide 13,200mm2 of
fixed ventilation.
Heki 4 Remote Control (coded)
The remote control is ready for use after
inlaying the two batteries. It functions from
a max distance of approx. 1.5 m from the
Heki rooflight (the remote control and control
system have a non-volatile memory). The red
lamp is blinking when starting current again
after an interruption of the power supply to
the Heki rooflight. By pressing a button of the
remote control (e.g. lighting) in the direction
of the red lamp (picture A) this red lamp goes
out. The control lamp is switched off when the
glazing panel is closed. If the glazing panel
is not closed completely the control lamp is
lighting. In case of dysfunction see point 11 of
the installation instructions.
Opening/closing the acrylic dome
Hold the remote control in the direction of the
red control lamp.(Fig. A) By short pressing the
button 1 , the glass dome will be opened up
to 70 degrees.
Should an opening up to 70 degrees not be
required,this could be interrupted by pressing
the button 1
once again.
Press the button 2
permanently for closing
the roof until the desired position is reached.
The control lamp is switching off when the
glazing panel is completely locked. Check the
locking through lifting the glazing panel!
! WARNING
Do not operate the remote control when
there are persons near the HEKI rooflight.
Do not stop in the vicinity of the open acrylic
dome.
Do not climb on the roof through the open
acrylic dome.
The rooflight closes automatically
through erroneous contact with the rain
sensor, as well as contact with humidity
(fog,rain,condensation). Before setting off
close the acrylic dome and open the blinds.
MIDI HEKI ROOFLIGHT HEKI ROOFLIGHT