Operating instructions

FITTED EQUIPMENT
105
FITTED EQUIPMENT
104
+22°C
ON
2 kW
OnOf
f
Note: if “Standby Brightness” is set to Off,
the display goes out when it enters standby
mode, but lights up if you press the screen.
See settings under 9.12.
4. Set the required temperature
The temperature can be set from +5°C to
+30°C in steps of 0.5°C. Warm water is
always available (50°C) when the boiler is on
and running on LPG and/or electricity. During
summer, when only warm water is required,
adjust the temperature setting to well below
the surrounding temperature so that central
heating circulation is not called for.
+22°C
ON
2 kW
OnOf
f
1. The temperature displayed is the
temperature which is set at present (in this
case 22.0°C).
2. Raise the temperature by pressing the +
button. Lower the temperature by pressing
the – button.
3. The settings are ready and the central
heating will circulate at the set temperature.
5. Hot water boost
If you need more warm water, you can raise
the water temperature temporarily from 50°C
to 65°C. After 30 minutes, the boiler reverts
to normal operation. While hot water boost is
activated, the circulation pump is stopped.
+22°C
ON
2 kW
OnOf
f
1. Increase the quantity of warm water by
pressing the + button. When activated the
plus symbol changes colour to green.
2. The settings are ready.
If you wish to revert to the basic warm water
settings before 30 minutes have expired.
+22°C
ON
2 kW
OnOf
f
1. Reset the warm water by pressing
the – button.
2. The settings are ready.
6. Heating with electricity
Do as follows to active heating with electricity.
The greater the power, the better the heating
performance. In choosing between electricity
A green LED comes on beside the On-/Off
button when the panel/boiler is on.
2. The control panel in standby mode
Note: if “Standby Brightness” is set to Off,
the display goes out when it enters standby
mode, but lights up if you press the screen.
See settings under 9.12.
A. Clock
The clock shows day and time. Theclock is set
under section 9 point 2.
B. Outdoor temperature
The outdoor temperature is displayed
only if an outdoor temperature sensor is fitted.
C. Indoor temperature
The indoor temperature is displayed
automatically.
D. Circulation pump
This symbol is displayed when circulation of
the central heating is called for.
E. LPG bottle full/empty
This symbol is displayed when the sensor on
the cylinder changeover is connected and
activated in accordance with section 9 point 8.
F. 230 volts
This symbol is displayed when 230V is
connected to the boiler.
G. MENU button
Button for setting menu.
H. On/Off button
Shut down / turn on the boiler
3. From standby mode to setting menu
When on standby, the indoor temperature is
displayed, and the outdoor temperature is
displayed if an outdoor temperature sensor
has been connected. The background lights
up when you press the screen or the MENU
button. Start the setting menu by pressing
the MENU button. The background lights up
and those functions which can be set are
displayed. The settings are automatically saved
after 10 seconds. The control panel reverts to
standby automatically after 30 seconds if no
buttons are pressed (or if the MENU button in
the setting menu is pressed).
1. The control panel in standby.
+22°C
+6°C
Fri 18.30
2. The control panel in setting menu.
ALDE HEATING OPERATING INSTRUCTIONS