Operation Manual

13
GB
Inst Acc
Glykol pump tank
External panel
Load limiter
The rst time you use the heating system, check that the correct accessories/functions are activated. This also applies
when new accessories/functions have been added to the heating system. Activate accessories/functions by pressing
Installed Accessories (see gure 1). This will take you to the activation menu for accessories/functions where a check
in each function/accessory will activate it.
Settings
Figure 1
Figure 2
Inst Acc
Main Remot 12V
Main Manual 12V
Main 230V
Inst Acc
Duo Control
Booster
Load limiter
Inst Acc
Aux Hot Water Tank
Underfloor Heat Pump
Engine Pre-Heat Pump
Figure 3
Figure 4 Figure 5
Connected an external panel or Alde Smart
Control.
Connected an extra 12 V pump, often loca-
ted in the expansion tank.
Connected a load monitor.
Connected a 12 V pump that is variably
adjustable with a potentiometer knob.
Connected a PWM controlled 12 V pump
with variable speed control that is set from
the panel.
Connected a 230 V Pump.
Connected a Booster.
Connected a bottle changer (DuoCom-
fort or DuoControl).
Connected a defroster (EisEx).
Connected a 12 V pump to the oor
heating.
Connected an extra heater to increase
warm water capacity.
Connected a 12 V pump for heating
the vehicle's engine through the Alde
heating system.
11. ACTIVATING INSTALLED FUNCTIONS
The respective box should be checked if you have:
Functions marked with a (*) are accessories, which are not installed on all vehicles, refer to the vehicle
manufacturer's instructions.