Operation Manual

16
INSTALLATION INSTRUCTIONS – CONTROL PANEL 3020 113
Control panel 3020 113 is intended for the Alde Compact 3020 High Efciency boiler.
The control panel should be located at least one metre above the oor, but not too close to the ceiling. Nor should it be
located on an outer wall or close to items which radiate heat, such as a CD player, refrigerator or lamps, as this may
result in incorrect temperatures. The space behind the panel should be well ventilated. If the room thermostat on the
panel is still affected, an external sensor should be connected to the panel.
Make a hole for the control panel as shown in Figure C. Screw the control panel securely in place and push the front
cover into position. Secure the cable with clamps to prevent any strain on the terminal strip of the panel.
C.
B.A.
84 mm
73 mm
R3(4x)
76 mm
87 mm
9 mm
38,5 mm
86 mm
97 mm
CABLE CONNECTION COMPACT 3020 HIGH EFFICIENCY AND CONTROL
PANEL 3020 113
Connect accessories to the boiler and control panel as shown in the diagram below. NB! Do not clamp 12 V cables or
sensor cables together with 230 V cables. It is best not to position the cables close to one another. If the cables are
bundled together, there is a greater risk of malfunction during operation.
Control panel rear
*Truma Aventa Comfort AC is con-
nected to one of the TIN Bus con-
tacts.
V-302013 Rev 1445
3020
+
Battery Back-up (3V DC)
Remote Sensor 1
Remote Sensor 2
Sofa
Bed
Heater
TIN Bus
External panel
Fuse 3,15 A
12 V DC
12 V
pump
Control panel
Tin bus
Option board/
Mechanical panel
External
start
Window
circuit breaker
Overload
protection
Outdoor
sensor
D
E
I
F
Circuit board on Compact 3020 HE boiler
Option board for Compact 3020
Mechanical panel 3010 214
OUT 12V DC
CONNECTED TO
HEATER MAINBOARD
FUSE 3,15 A EXTRA HOT WATER PUMP EIS EX HEATER MAINBOARD 12 V DC
+
-
Optionsplatine für Compact 3020