Operation Manual
Commissioning of your satellite system.
1. Make sure that the antenna can stand and rotate without encountering obstacles (branches, buildings, telephone
relays, etc.) during reception or operation.
2. Switch the main switch located on the underside of the AIO SATMATIC-HD to position 1 (on) to turn the power on.
3. Activate your AIO SATMATIC-HD by pressing the button on your remote control. The start-up phase can last up
to 30 seconds. If your antenna is not yet oriented, the antenna will rise and orient itself automatically. The system is
pre-programmed to automatically start the search on the last selected satellite. During this automatic search operation,
the antenna pointing information bar is displayed:
Commissioning of your satellite system
When the automatic antenna orientation is successful, a double beep will sound and this information bar will be
displayed for 10 seconds and then disappear automatically in the absence of manipulations on your part with the remote
control. The start-up phase of your AIO TV then continues until you get an image.
• (green) Satellite: Allows to change satellite.
• (red) Close: Allows the automatic antenna to be closed.
• (blue) Info **: Informs about the conguration of your TV AIO.
• (yellow) Diag **: Informs about the parameters of your automatic antenna.
** The satellite cannot be found when this function is requested.
Anm. d. Übers.: Klingt unverständlich. Was genau ist hier gemeint? Vielleicht besser so:
** This function is required if the satellite cannot be found.
IMPORTANT: When using the system for the rst time, or during large trips, it is possible that the search takes more time.
WARNING: Activating the vehicle contact prevents manipulation of the antenna. Check that the vehicle contact is
deactivated.
NOTE 1: During the automatic search phase of the satellite, it is possible to control the antenna manually by using the 4
directional buttons on the remote control. Pressing the OK key will restart the search in automatic mode.
NOTE 2: When a satellite channel is displayed on the screen, it is possible to display the satellite search menu again by
pressing the green button on your remote control.
At the end of use
1. Press the button on your remote control. Then select the action to be performed on your antenna.
2. The AIO SATMATIC-HD then switches to standby mode (consumption <1W).
3. Switch main switch to 0 (o) to turn o the power.
WARNING: The warranty is void if you forget to fold the antenna.
Page 10