ALECTO DBX-90 Owner’s Manual (DRAFT) 1.
TABLE OF CONTENTS Safety Information Getting Started Unpacking Out of Range Low Battery Charging the Battery Restore to Default Setting Baby Unit Parent Unit Appendix: Default Settings Basic Steps to Install Wall mounting the Baby Unit Power On/Off Environmental Care Recycling & disposal Monitoring Sensitivity Adjusting Volume Talk Back Paging Nightlight Lullaby Playing the Lullaby Stopping the Lullaby Playing 2
Safety Information Baby Unit • • • • • • • • • • Avoid exposure of the units to moisture or liquid. Clean the units with a damp cloth. Do not expose the units to extreme heat or direct sunlight. To prevent electric shock, do not open the cabinets of the baby unit, parent unit and charger. Avoid metallic contact (e.g. metal clips, keys) between the battery contacts and charging conductors. Read the marking on the mains adapter for the mains supply required for this baby monitor.
Parent Unit Basic Steps to Install 1. Connect the output plug of the mains adapter to the DC socket at the back of the baby unit and the mains adapter to the wall mains supply. 2. Plug the charger adaptor for the Parent Unit into the mains power socket. 3. Remove the battery door on the Parent Unit by lifting the battery door outward. 4. Insert 2 x AA rechargeable batteries, observing their polarities, into the battery compartment on the Parent Unit. 5. Replace the battery door on the Parent Unit. 6.
Wall mounting the Baby Unit Power On/Off Use the following wall mount template to locate and install the mounting pins/screws if you prefer to wall mount your base unit. The dimensions are shown in millimeters (mm). Baby Unit • To switch on, press . The Green Link light comes on to show that the units are within range of each other. • To switch Off, press light goes off until the display goes blank and the link Parent Unit • .
Sensitivity Paging You can adjust the sensitivity on Parent Unit to monitor the sound from Baby Unit. For example, if your baby is a particularly quiet sleeper, you can increase the sensitivity levels so that you are sure to hear if baby disturbs or becomes uncomfortable. If the Parent Unit is misplaced, you can use the page button on the Baby Unit to locate the Parent Unit. • Press on the Baby Unit. The Parent Unit will sound the paging alert.
Parent Unit • Press at the Parent unit when lullaby is not being played. Stopping the Lullaby Playing Baby Unit When lullaby is playing, to stop the Lullaby. • Press Parent Unit When lullaby is playing, • Press alert message and alert tone will be turned off when fully charged batteries are being replaced. Note: Low battery alert can be suppressed by pressing any button. Charging the Battery Place the parent unit on its charge cradle to charge the battery.
Environmental Care Please remember to observe the local regulations regarding the disposal of your packaging materials, exhausted batteries and old product and, where possible, promote their recycling. Packaging information: (Customer’s name) has marked the packaging with standard symbols designed to promote the recycling and appropriate disposal of your eventual waste. The labeled packaging material is recyclable.
