User Manual

Electronic Time Switch
Function:
Connect devices to the DTS-814 to
have them switch on and off automat-
ically.
The switching assignments are per-
formed to the exact minute.
Up to a maximum of 20 different
on and off switching times may be
programmed; these can be repeated
daily, weekly or for only part of the
week, according to your requirements.
A built-in rechargeable battery main-
tains the time and programming data
in case of a mains power outage and
allows you to program the switching
times with the timer disconnected
from the outlet.
Preparation:
1.
2.
3. Set the on/off switch of the device
or lamp you’ll be connecting to the
on position
To set the actual day and time:
Press and hold the CLOCK
button during the setup.
Repeatedly press the DAY
button (or briefly press and
hold) to set the day (*)
Repeatedly press the HOUR
button (or briefly press and
hold) to set the hours
Repeatedly press the MIN
button (or briefly press and
hold) to set the minutes
Finally release the CLOCK button
and the actual time and day are now
stored
*: MO = Monday
TU = Tuesday
WE = Wednesday
TH = Thursday
FR = Friday
SA = Saturday
SU = Sunday
DTS-814
Daylight saving time:
Press and hold the CLOCK
button for 3 seconds to set
the clock to summer time;
press and hold again for 3
seconds to set to winter time
Set to
summer time
To set the switching times:
Up to a maximum of 20 different
on and off switching times may be
programmed; these can be repeated
daily, weekly or on a combination of
days, according to your requirements.
Repeatedly press the SET
button to select your desired
programme step and to
determine whether this must
be a switch on time (ON) or
switch off time (OFF)
Repeatedly press the DAY
button to set the day or a
combination of days
Repeatedly press the HOUR
button (or briefly press and
hold) to set the hour
Repeatedly press the MIN
button (or briefly press and
hold) to set the minutes
Press the SET button to
program the following pro-
gramme step
or press the CLOCK button
to end the programming
process
To check & adjust the switching
times:
Repeatedly press the SET
button; the display shows all
programme steps one after
the other
To change:
Use the DAY, HOUR or MIN
button to adjust the selected
programme step
To remove:
Use the SET button to recall
the concerned programme
step in the display
Press the RECALL button to
delete this step; the display
now shows: --:--
To undo a deletion:
Use the SET button to recall
the concerned programme
step in the display
Press the RECALL button
and the switching assign-
ment will be active again
10hr
3 sec.
+/- 1 hour