User's Manual

“The Stocky” User Guide
Page 9 of 29
5.5 Clearing Sessions in “The Stocky
You can clear “The Stocky” from the keypad. To do this hold down the New Session
button and press the read switch 3 times. When The Stocky” is cleared a long beep
will be heard.
NOTE: Once the unit is cleared the session(s) data in not recoverable.
5.6 Using the RFID Counter on “The Stocky”
(On 7020 & 7020BT models only)
On the 7020 & 7020BT models the RFID Counter is located on the side of the unit
above the computer/charger connection.
The RFID Counter counts the number of devices read in the current session. When
you create a New Session the RFID Counter resets back to 0. It also resets to 0 when
you clear the unit.
5.7 Using BlueTooth in “The Stocky”
(On 7000BT & 7020BT models only)
To turn the BlueTooth on press and hold down the NEW SESSION button and then
press the ON button. The BlueTooth LED will come on.
To return back to a serial connection repeat the above process. The BlueTooth LED
will go out. 2 beeps are heard if BlueTooth is enabled or 3 beeps if Serial is enabled.
Notes:
1. The BlueTooth Feature is only available if you have a 7000BT or 7020BT model.
If you don’t your unit can be upgraded for this feature. Contact the supplier for
further information and costing.
2. BlueTooth is a way you can communicate to a PC, PDA or other device without
using the serial cable, referred to as a Wireless connection.
3. The PC or device that the 7000BT or 7020BT is going to communicate to must
have BlueTooth fitted. The PC or device sets up the link between the two units.
5.8 BlueTooth PIN code
The Pin Code or access code, as it is sometimes referred to, is the 4 digit serial
number on the side of the 7000BT or 7020BT.
If the sticker is missing when you discover the 7000BT or 7020BT on the PC or
device, the 4 digit number which comes up in the name of the 7000BT or 7020BT
discovered is the pin number.
Refer to your PC or other devices manual to see how to discover and connect to a
BlueTooth device.