Use and Care Manual
7
www.AlekoDrywallSander.com
Important!
When using equipment, a few safety precautions must be observed to avoid injuries and damage. Please
read the complete operating manual with due care. Keep this manual in a safe place, so that the
information is available at all times. If you give the equipment to any other person, give them these
operating instructions as well. We accept no liability for damage or accidents which arise due to non-
observance of these instructions and the safety information.
1. Safety regulations
The corresponding safety information can be found in the enclosed booklet.
CAUTION!
Read all safety regulation and instructions.
Any error made in following the safety regulations and instructions may result in an
electric shock, fire and/or serious injury.
Keep all safety regulations and instruction in a safe place for future use.
2. Machine Components (Fig. A)
1. Machine body
2. Disk module
3. Hose. Drive shaft
4. M4*12 Screw,Ф4 Flat washer, Ф4 Spring washer
5. Dual lead dust hose (with 2pcs clip)
6. 1.5m extraction hose
7. U handle
8. Adapter connector
9. Carton brush
10. Sander paper
11. Allen wrench
12. Screwdriver
3. Assembling of disc (Fig. B1 /B2)
3.1 Loose M4*25(1) bolt via wrench then take linking piece. (2)
3.2 The disc component of tube bending hole (3) aim at convex platform of gear box
cylindrical. (4) Used M4*25 bolt, Ф4Spring washer (1) andФ4 Flat washer to lock
clamp to gear box.
4. Drive shaft & drive shaft Assembling (Fig. C1-C6)
4.1 Shaft end of hose with threaded (1) insert to hole of the disc component(2) (Note: shaft
should be installed in position)
4.2 Insert the hose(3) to the bearing of disk, and the clockwise tighten
4.3 The drive shaft(1) other end into the motor output in axle hole(5) (Usable hand low speed
rotating glue plate, the soft shaft inserted smoothly) Then the hose inserted into gear box in
the holes.(5)
4.4 Used M4*12 bolt, Ф4 Spring washer
4.5 andФ4 Flat washer(6) to lock clamp to gear box.(5)
4.6 With plier clamped soft management (7) sets, the card will be in gland.
5. Dual lead dust Assembling (Fig. D1/D2)
5.1 Will double guide dust tube (1) insert into the disc (3) use a word screwdriver (3)
lock, make double guide tube (1) fixed on the disk (2) in the dust.