Use and Care Manual

9
www.AlekoDrywallSander.com
Caution:
The vibration value changes according to the area of appliance of the electric tool and
may exceed the specified value in exceptional circumstances.
Keep the noise emissions and vibrations to a minimum.
 only use appliance which are in the perfect work order.
 Service and clean the appliance regularly.
 Adapt your workings style to suit the appliance.
 Do not overload the appliance.
 Have the appliance serviced whenever necessary.
 Switch the appliance off when it is not in use.
 Wear protective gloves.
9.Before staring the appliance
Before you connect the appliance to the mains supply make sure the data on the rating plate
are identical to the mains data.
Always pull the power plug before making adjustments to the appliance.
9.1 Changing the abrasive paper (Fig.2)
The sanding/grinding disk comes with a Velcro fastening system for sanding / grinding paper.
This permits new sanding / grinding paper to attached without a clamping device.
Before you attach a new piece of sanding / grinding paper ,knock out any dirt from the Velcro
fastener and clean with a brush or, if necessary with compressed air.
Place the sanding /grinding paper on the sanding /grinding disk. Fix the sanding/grinding
paper in the place by pressing it firmly with your hand.
Caution:
Only grinding wheels with the specified diameter may be used.
9.2 Fitting the dust extraction system (Fig 3/4)
The dust extraction system prevents the accumulation of the dirt and high dust loads in the
air, and it makes it easier to dispose of the dust.
 Insert the dust extraction hose (6) into the mount (5) Both interlocking lugs (a) should to
be snapped into the notches (b) in the mount.
 To dismantle the hose, carefully press into the notches with the flat side of the enclosed
screwdriver. By doing this ,the interlocking lugs are released from the notches and hose
can be taken back out of the mount.
 Connect your appliance to an extraction unit or vacuum cleaner. This will provided
excellent extraction of chips and dust from the workplace.
 Advantages: The advantages are that you will protect both the appliance and your own
health. Your work area will also be clean and safe.
10. Staring up
10.1 ON /OFF switch (Fig.5)
To switch on the appliance set the on/off switch (1) to position 1.
Move the on /off switch (1) to position 0 to switch off the appliance.
10.2 speed controller (Fig.5)
To pre-select the speed turn the knurled screw (2) on the switch.
Plus direction: Higher speed
Minus direction: Lower speed