Instructions / Assembly

AR2000 SLIDING GATE OPERATOR
7
Fig.6
Magnets for limit switch
Install the magnet as shown in Fig.7 and Fig.8 below. The magnet and limit switch are used to
control the position of the gate.
When the magnet is installed, release the gear clutch and push the sliding gate manually to
pre-determine the position. Fit the magnet bracket to the rack and then tighten the gear clutch.
The lower bracket is for open position and higher bracket is for close position. Fix the magnet to
the bracket. Finally adjust the magnet to the proper position by moving the gate with the motor.
The magnet should be 10~15mm away from the magnetic limit switch. If it is too far away, the
switch will fail to work. Adjust the position of the magnetic limit switch until the positions of the
opening and closing meet the requirement.
Fig.7