Installation Guide

15
🔨 REPAIR MANUAL
CASE OF MALFUNCTION REASON REPAIR METHOD
1
The awning does not work when
operated by the remote control.
1. There is no power supply.
2. The residual current automatic
circuit breaker is turned to “o.”
3. The voltage is too low.
1. Check the plug to see whether
it is properly connected.
2. Call a professional to inspect.
3. Call a professional to inspect
the voltage.
2
When operated by remote control,
the awning does not work, although
you can hear the signal sound from
the remote control receiver.
1. The remote receiver and motor
are switched or the wire from
the motor is disconnected.
2. The motor switched o due to
the overheat protection.
1. Check two places: fasten pins,
and the screws.
2. The motor will automatically
resume operation after approx-
imately 20 minutes.
3
The fabric is loose, even though the
awning is extended entirely.
The path length is incorrectly ad-
justed.
Readjust the path length according
to the direction of the motor.
4 The cassette can’t close completely.
The connecting position between
the front bar and the front beam.
Adjust the position of the front
beam until the cassette is entirely
shut.
5
There is unwanted noise when
operating the awning.
There is a loose screw.
Check all screws to ensure that they
are tightly fastened.
6
When operated by a remote con-
trol, the indicative lamp does not
work and there is no signal from
the receiver.
1. The cell is exhausted.
2. The cell is disconnected.
1. Replace with a new cell.
2. Reset the cell.
Common mistakes
Fabric
Correct operation Wrong operation
WARNING: When the front bar
touches the roller as shown in
the gure, don't try to make them
closer, otherwise the product
may be damaged.
Fabric
Front Bar