Installation Guide

WARNING DO NOT REMOVE THE SAFETY SLEEVES THAT HOLD THE ARMS DOWN!

🔧 ASSEMBLY

Connect Arm Bar to the Assembled Front Bar.

• Before assembly, inspect the wrapping on the arm bar (L) and make sure the wrapping is intact.

Arm bars are spring-loaded and can cause serious damage or injury during assembly.

• Insert blocker (P) into side slot of assembled front bar (C) and carefully thread the blocker to the

middle of the front bar.

• Insert blocker (P) into side slot of assembled front bar (C) from the other side and carefully thread

the blocker to the middle of the front bar so the two blockers are side by side.

• Insert arm bar link (Q) to each end of the front bar (C) near the head of each arm (L) which are

attached to the torsion bar (B).

• Attach the arm bar link (Q) to the top of each arm (L) and tighten with a wrench.