Instructions / Assembly

STEP 5: Mounting the Awning

1. Now that the wall brackets are secure and in place, it is time to

install the awning onto the brackets.

2. At least two ladders or sturdy chairs are required to install the

awning.

3. Put the original expansion bolts on the wall brackets and

tighten them.

4. Finally, fasten all expansion bolts.

5. Using the hand crank or a motor (if applicable), fully open your

awning. The front bar should be level.

6. Congratulations! Your awning is installed. If you are happy

with the height of the front bar (awning pitch), sit back and

enjoy! If not, please read on.

ADJUSTING THE AWNING PITCH/ANGLE

Each awning comes with a pre-set pitch (angle) that is considered ideal. However, if you need to make an adjustment, it

can be done in just a few easy steps.

☻ OPTIONAL INSTALLATION

IMPORTANT: Raising the front bar will reduce the pitch (angle) of the fabric, thus

increasing the risk of rain water pooling on the fabric. To prevent the awning from

collapsing due to rain water weight, you must retract the awning when unattend-

ed. Failure to do so could result in a broken awning or personal injury.

Note: Be sure that the front bar is adjusted to be completely even. Any misalignment will result in improper retraction.

Jack Bolt

Tighten

Loosen

to adjust