Instructions / Assembly

STEP 8: Center Support Assembly

1. With a mallet or hammer, tap left roller supports (U) with the motor bracket into the torsion bar.

2. Tighten the bolt to secure the roller support.

STEP 7: Left Roller Support Assembly

NOTE: Your awning will come with the roller support attached. Refer to this step if installing a replacement part.

Otherwise, proceed to step 8.

1. With a mallet or hammer, tap the left roller support (D-1) with the motor bracket into the torsion bar.

2. Tighten the bolt inside of the roller support with a wrench.

D-1

STEP 9: Roller Support Assembly

1. Find the motor (F-1) located in the roller tube. Insert this into the motor bracket (D-5), as shown in step 1 on the

diagram below.

Step 1

F-1

Insert in

D-5