Instructions / Assembly

11
2. Using a mallet, knock the round shaft cover (E-2) into the right roller support (E-1).
3. Now, link the roller support into the round shaft (F).
4. Use a wrench to tighten the roller support.
5. At this point, the roller tube and the roller support will be fully secured together, as shown on the diagram below.
STEP 10: Setting Awning Position
WARNING Be sure that the safety sleeves holding the two front bar arms are
secured to the torsion bar. Failure to check this could result in injury.
1. Move the blocker to the middle of the arms and fasten.
2. Then, move the arm bar link until the front bar wrist support is connected through it.
3. Align the front bar and the arm, and tighten the self locking nut upwardly with a screwdriver.
4. Then, tighten the adjustable bolt up to 90% tight using a ribbon tube spanner (as seen below).
Steps 2 - 4
Insert in
F-1
D-5
F
E-1
Step 5
Steps 1 - 4
Tighten
Insert in
Tighten Tighten
E-2