www.aleko.
35 5 6 16 Nest Swing & Glider - BSW08 Attach Swing to Assembled Frame Nest Swing Assembly F5 16 16 F5 F3 (x4) (x4) F3 6 Fig. 1 6 F3 Step 1. Completely disassemble F1 U-Bolts then place u-shaped bolt through the hole in the bearing assembly found at the end of the Swing ropes. Step 2. Tighten open-ended F1 nut down onto u-shaped bolt, place 1 F1 washer on each end of the bolt and insert into Top Bar through 2 sets of vertical holes. Ensure washer placement between nuts and Top Bar. Step 3.
Glider Assembly Step 5. Insert tapered segment of Glider Legs into exposed open side of Glider Handle Tubes, use 2 G6 fasteners on either side to attach. 43 G7 83 Fig. 3 Fig. 2 Step 6. Insert 1 G9 Plastic Spacer into either side of the holes near the center of the Glider Legs (Fig. 4). Step 7. Attach the Glider Seat Tubes to either side of the Glider Legs by placing a G4 fastener through the same holes that the G9 Spacers have been installed in. Step 8.
35 5 6 16 Nest Swing & Glider - BSW08 F5 16 16 43 F5 F3 (x4) (x4) F3 6 6 F3 M6 BOLT 32mm (x4) M6 BOLT 52mm (X12) F5 M8 BOLT 59mm (X1) M8 BOLT 65mm (X4) Anchoring Swing Set to the Ground F6 M6 BOLT 60mm (X4) Step 1. Attach Ground Pegs to all 4 Nest Swing Bottom Legs using F6 fasteners. Step 2. Place assembled Swing Set in desired location and dig a footing hole, measuring 12" (30cm) Long x 12" (30cm) Wide x 20" (50cm) Deep, at the base of each support leg. Step 3.
