GATE INSTALLATION INSTRUCTIONS www.AlekoGates.com MANUAL FOR DUAL DRIVEWAY GATE INSTALLATIONS KENT, WA 253.872.
Table of Contents Important! Call Utillity Locate Before You Dig .................................. Confirm Local Building & Safety Code ............................................ Hardware Packet...........................................................................1 Tools Needed ................................................................................1 Gate Size & Installation ..................................................................1 Part 1 of 2 Post installation ....................
Hardware Packet 2 Panels of Gates (in case Dual Gates) or 1 Panel of Gates (in case Single Gates) 2 Posts 4 Hinges (in case Dual Gates) or 2 Hinges of Gates (in case Single Gates) 1 Set of Bolts and Nuts Tools Needed Tape Measure …A Can of white paint (Athletic Striping)… 2 Stakes… Mallet… Quick Set Concrete (7-8 bags). ..
Part 1of 2 Install Posts Mark the post locations with a 1.800.332.2344 (X) in white paint and call After utilities have been located dig holes 36” deep. Place posts in holes and check for level and correct distance apart. Pull the string level firm from post to post points. Adjust height of posts pounding down on the Posts or adding site debris under the post to get the correct bottom of the gate height. Mix concrete & fill holes taking care to not move the posts. POSTS NEED 3-4 DAYS FOR CONCRETE TO SET.