Instructions / Assembly

🔨 HANGING THE DOORS
Remove the glass windows from the door by unfastening the latches and pulling them open so the windows can be lifted
o from their hinge pins.
Make sure the hinge bearings are installed. The hinge bearing is a thick brass washer that must be in place on each
hinge pin. The two heavy hinges should receive a VERY light application of oil or grease on both sides before the doors
are hung. Do not get grease onto the painted surfaces, as this can cause damage.
Apply the oil or
grease on both sides
of the hinge before
the doors are hung
Hinge Bearings
Hang the Door Slabs On the Jamb
Lift each door onto its hinge pins. After the doors are
hung, use the ush bolts on the edge of the inactive
door to hold it closed.