Installation & Instructions ALEKO Multi-functional RV/PatioAwning W20190918EN ARVAW010 www.AlekoProducts.
CONTENTS P a c k a g e C o m p o n e n t s . . . . . . . . . . . . . . . . . . . . . . . P. 4 P r e p a r a t i o n . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . P. 5 I n s t a l l a t i o n . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . P. 6 - P. 11 O p e n s t e p s . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . P. 1 2 C l o s e s t e p s . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
ALEKO Package Components 5 Preparation 1. Open the package and check all parts and accessories on the package components. Insure nothing is missing in the package box. 2. Prepare the installation tools, like electric hand drill, hand plier, measuring tape, screwdriver, an erasable color pen ect. 3.
Imperial system measurement ALEKO Please insure the arms are vertical to the ground and parallel to each other ! Awning width(A) 5.12 69.90 REMAKE: A,represent awning width. Please check above measurement sheet carefully, and calculate the correct installation position accordingly. Φ4.2x35 65mm The fabric lock rail is between two upper brackets,but keep them in the same height position.
ALEKO Step 8 Please kindly remove the right side end cap from fabric tube and then take out the springs. Then put the fabric into fabric tube according to below steps. If you choose a modular type , please connect the fabric tube first. 1) Find the poly cord and get across fabric loop. Connect the fabric tube 3) Put the fabric into second fabric tube groove, then get the poly cord across. AA M6x16 screw B Poly cord B A 2) Put the fabric into the fabric tube groove.
Step.9 Connect the right arm ALEKO 1.Turn down the Safety-spring lock according to the PIC marked direction (On and ONLY the RIGHT side of the fabric tube,there is a Safety-spring lock) 2.Make Pre-stress for right side spring by turn the sping ending stick with clamp/screw driver fully turn 15 turns according to pic marked diretion 3.
Open steps ALEKO Step.1 Step.2 Release the inner and outer arm-lock each side. Turn down the spring lock according the pic. marked direction. Step.7 Step.8 Release the outer arms from their bottom brackets by pushing the little lever. Take care that the construction won't be twisted too much doing so. You may post the outer arms in a good 90 degree angle to the ground. Now adjust the necessary height and then fix the tubes with their locks. Fix the bottom plates of the poles with the steel-peg.
Close steps Step.3 Open Step2 Step.4 ALEKO Now open the handle-lock and slide the two tubes of the outer arms into another. Turn the wheel-lock. AWNING CARE AND MAINTENANCE CARE Regularly check if the awning fasteners keep tight , if not, please tight all fasteners. And Periodically clean the awning fabric and arms. HOW TO CLEAN FABRIC Monthly flush off the awning fabric with clean water and thorough cleaning the fabric with soft brush and warm water every one or two years. Step.5 Step.
