Use and Care Manual

www.ALEKOPRODUCTS.com
4
Awning Assembly
WARNING: DO NOT REMOVE SAFETY BANDS FROM THE ARMS UNTIL INSTRUCTED TO DO SO.
Step 1: Put the fabric tube coupler (10) into
the fabric tubes A & B (3&4). Apply a thin
coat of super glue to all self-tapping
screws (18) and use them to secure the
coupling.
Step 2: Slide the flexible fabric rod (6)
inside the two sleeves, one on each side of
the fabric (5).
Step 3: Place the fabric tube so that the
square dowel is facing the end where the
gear box will be located (left end). Then
insert one side of the fabric into the fabric
tube. Note: The folded edge of the fabric
has to face the ground.
Step 4: Spin the fabric tube to get all of the
fabric rolled tight around the tube.
Step 5: Insert the square bar coupler (8)
into the square bar on the awning frame A
(with the gear box) (1), fasten them with one
square bar connection bolt (15).
Step 6: Put the front bar coupler (7) inside
the front bar of the awning frame A (with
the gear box) (1). Then insert the front bar
fastener (10) into the bottom channel of
the front bar.