Alen BreatheSmart Air Purifier ® USER MANUAL ® www.AlenCorp.
TABLE OF CONTENTS Air Purifier Safety 4 Using Your Air Purifier Operating Your Unit Identification Of Parts 4 Know Your Air Purifier 7 Care & Maintenance Replacing The Filter Why You Should Replace Your Filter Alen’s AutoShip Filter Plans How To Replace The Filter How To Clean The SmartSensor 7 Troubleshooting Tips 10 Lifetime Limited Warranty 10 www.AlenCorp.
AIR PURIFIER SAFETY Provided in this manual are important safety messages regarding your electrical home appliance. Always read, follow, and save all safety directions. Location Requirements • • • • Use a level surface at least 6” (15.2cm) from heat sources such as ranges or heaters. Do not block air vent openings or place air purifier on a soft surface such as a bed or sofa. Never insert fingers or foreign objects into air grills or vents. Operate indoors only.
USING YOUR AIR PURIFIER Operating Your Unit: 1. Plug your air purifier into a grounded outlet. 2. Press Power Button in the center to start the air purifier. When your unit is on, the lights will light up. To turn off the lights on your unit, press the Power Button. To turn off the air purifier, press the Power Button again after the lights have turned off. 3. The Colored Light around the by the particle sensor.
Identification of Parts (numbers correspond with directions on previous page): 4. Optional ozone-safe ionizer. 5. Notifies you when it’s time to replace the filter. 6. Press for 5 seconds after changing filter to reset to green. 8. Press to select one of four fan speeds. Lights will display selected speed. 7. Four, eight, and twelve hour timer to control air circulation. 9. Automatic mode sets speed for optimal performance. 2. Press to START or STOP your air purifier.
KNOW YOUR AIR PURIFIER When using the air purifier for the first time in a room, we recommend that you use a higher fan speed like speed three (3) or Turbo (T), for at least two hours in order to clean the room’s air initially. Then, we recommend that the air purifier run continuously on speed two (2) or three (3) or be set on automatic mode.
Why You Should Replace Your Filter • Fulfills the terms of Alen’s Lifetime Limited Warranty which states that the filters are required to be changed on a regular basis in order to prevent excessive stress on the unit. • You have bought an Alen Air Purifier to improve the quality of your indoor air. Changing your filters will maintain the level of air quality you require. Excessively dirty filters can compromise the level of clean air your air purifier can provide.
3. Remove the used filter by pulling out on the pull strings. Place the used filter in a plastic bag to prevent dust from re-entering the air. 4. Take the new filter out of the plastic bag and insert it into the air cleaner with the pull strings facing outward. 5. I nsert the top tabs of the front cover first and then the lower part of the cover will snap into place. WARNING! RISK OF ELECTRIC SHOCK - These servicing instructions are for use by qualified personnel only.
TROUBLESHOOTING TIPS How do I reset the filter indicator lights? I put in a new filter but the red or yellow lights are still illuminated. After changing the filter, RESET the filter indicator by holding down the FILTER LIFE button for 5 seconds while the unit is ON. The light above the FILTER LIFE button should reset to green. My BreatheSmart always runs on the highest speeds when in Automatic Mode.
while in normal use. Replacement parts or units will, at Alen’s option, be either new or refurbished. Alen’s sole obligation under this warranty is to replace defective parts or replace your air purifier free of charge. All parts or units that are replaced become the property of Alen. How to get service? This warranty will be valid only for units in possession of the original purchaser. Proof of purchase must be presented to Alen’s warranty service representative.
12 Copyright © 2012 Alen Corp. All Rights Reserved.