Specifications

22
… or …
Digital input:
AES/EBU
… or …
Digital input: S/PDIF
4. Use the UP/DOWN buttons to select the digital input that is to
be the source for recording: “ADAT”, “AES/EBU” or “S/PDIF”
(the corresponding Source LED on the AI-1 will be lit to indicate
the current selection);
5. To exit Edit mode, press the EDIT button (the EDIT LED will
turn off).
Note: If you change the Digital Input setting while the DIGITAL I/O
button is off, the AI-1 will not reflect the newly selected digital
input. However, the change will automatically be sent to the AI-
1 the next time the DIGITAL I/O button is turned on.
3.2B Bouncing Tracks Between ADATs
The BRC makes it possible to copy tracks between ADATs without
leaving the digital domain. The BRC assumes you have connected
the digital bus correctly between all ADATs in the system (see
section 2.1C). Digital track bouncing is a feature available regardless
of whether an AI-1 is connected, or not.
If the DIGITAL I/O button on the BRC is pressed again when its
digital input display reads "ADAT", you advance to the next
window where you may select which track(s) will be routed to the
digital bus, and thereby sent to any ADAT tracks that are in record
when the DIGITAL I/O button is enabled on the BRC. This allows
for digital track copying and backups.
To digitally bounce tracks from the BRC:
1. Press the EDIT button (the EDIT button LED will go on to
indicate you are in Edit mode);
2. Press the DIGITAL I/O button;
The display will read: