Specifications

24
onto any ADAT connected to the digital bus.
5. Press the EDIT button to exit Edit mode;
6. Press the DIGITAL I/O button to enable the digital bus (the
DIGITAL I/O LED will go on to indicate it is enabled);
7. Use the TRACK SELECT buttons on the BRC to record-enable
the destination tracks;
8. Initiate recording on the BRC.
• The source tracks will be recorded onto the destination tracks in
ascending order.
Example:
If source tracks 1, 2, and 3 are selected and tracks 12, 17, and 24 are
record enabled, then track 1 will be copied to track 12, track 2 to
track 17, and track 3 to track 24.
• If more destination tracks are selected than source tracks, the
source tracks will repeat (cycle).
Example:
If tracks 25 and 29 were added to the destination tracks of the
previous example, then track 1 would be copied to track 25, as well
as to track 12, and track 2 would be copied to track 29, as well as
track 17.
This type of scheme also allows for copying a single track to
multiple tracks.
• A digital source track cannot be selected as a digital destination
track (i.e. digital source tracks will not be allowed to be record
enabled when DIGITAL I/O is enabled).
• When copying digital tracks, any track delays and machine
offsets will be in effect.
3.2C Recording from AI-1 onto ADAT
If either AES/EBU or S/PDIF is selected as the Digital Input, any
ADAT tracks that are record enabled while DIGITAL I/O is turned