Specifications

32
Note: Even when the AI-1’s destination is set to AES/EBU, the
digital bus being received from the last ADAT is routed through
back to the first ADAT. Therefore, it is possible to bounce audio
from the last ADAT back to the first ADAT, while simultaneously
routing two tracks from the last ADAT to an AES/EBU device.
3.3B AES/EBU to ADAT (48kHz)
In this configuration, the ADAT optic jacks and the AES/EBU XLR
jacks are used. In the figure below, ADAT #1 is receiving from an
AES/EBU device using a 48kHz sampling rate. The proper control
settings for this operation are as follows:
Source = AES/EBU
Destination = ADAT
Destination Rate = 48kHz
Figure 6
3.3C AES/EBU to ADAT (44.1kHz to 48kHz)