User's Manual

12
Restore Factory Default Settings
To restore your Recital to the factory default settings, press and hold the Layer and Lesson buttons for 5
seconds. The following parameters will be reset to their default values: Reverb, Chorus, Metronome Tempo,
Metronome Time Signature, Metronome Volume, Upper Volume, Lower Volume, Split Volume, Split Point,
MIDI Channel, Touch Sensitivity, and Auto Power Off.
Troubleshooting
Problem Possible Cause and Solution
The speakers produce a
pop sound whenever the
power is turned on/off.
This is normal and is no cause for alarm.
The speakers do not
produce sound when the
keys are played.
Check if the master volume is set too low or if headphones are plugged into
the Headphone Output. The speakers will be muted if there are
headphones plugged into the Headphone Output.
If the issue is still occurring, press and hold the Layer and Lesson buttons
for 5 seconds to factory reset the voice volume settings of the unit.
The speakers are
producing noise or
interference.
Using a mobile phone in close proximity to the Concert Digital Piano may
produce interference. To prevent this, turn off the mobile phone or keep it
away from the piano.
Certain notes produce
the wrong pitch.
Make sure that the transpose value is set to 0. If that does not work, then
press and hold the Layer and Lesson buttons for 5 seconds to restore the
factory default settings.
The notes sound weak or
distorted.
If the keyboard is being powered with batteries, make sure new batteries
are installed.