Setup guide

e) Firmly tighten the memory lock’s bolt with
drum key.
f) Select either of the two Upright Tube / Rack
Base assemblies built in Step 1.
g) Slide the Right Side Tu b e ’ s T-Clamp onto the
Upright Tube. Position it approximately one foot
from the top of the Upright Tube. Loosely tighten
all wing nuts.
h) Set aside the completed Right Side Tube /U p r i g h t
T u b e / Rack Base assembly until Step 4 below.
3. Attach Left Side Tube to Upright Tu b e
a) Choose a T-Clamp and loosen all wing nuts.
b) Identify the Left Side Tu b e ( i t ’ s the tube with
t w o memory locks on it).
c) Attach T-Clamp to Left Side Tube by inserting tube into the clamp opening marked
“tighten first.” Make sure the tube is fully seated in the clamp. Loosely tighten the
wing nuts marked “tighten first.”
d) Loosen memory lock on the Left Side Tube and slide it into the T-Clamp, making
sure you align the memory lock’s notch with the indentation in the T- C l a m p .
e) Firmly tighten the memory lock’s bolt with drum key.
f) Select the other Upright Tube / Rack Base assembly built in Step 1.
g) Slide the Left Side Tu b e ’s T-Clamp onto the Upright Tube. Position it approximately
six inches from the top of the Upright Tube. Loosely tighten all wing nuts.
4. Attach Both Side Tubes to Center Tube
a) Take the two remaining T-Clamps and loosen all wing nuts.
b) Identify the Center Tube ( i t ’s the tube with t h ree memory locks on it).
c) Attach one T-Clamp to each end of Center Tube by inserting tube into the clamp
opening marked “tighten first.” Make sure the tube is fully seated into each clamp,
and rotate the clamps so that they are roughly aligned with each other.
d) Loosely tighten the wing nuts marked “tighten first.”
e) Insert top of left Upright Tube assembly into the T-Clamp on left side of Center
Tube. Insert top of right Upright Tube assembly into the T-Clamp on right side of
Center Tube.
f) For maximum stability, make sure that Rack Bases are perpendicular to the Center
Tube, with all four rubber feet in full contact with the floor. Also, make sure that
Center Tube is level, with each T-Clamp flush with the top of the Upright Tu b e s .
g) Loosen Center Tube memory locks and slide toward T-Clamps on each end. Slide
each memory lock into its respective T-Clamp, aligning each memory lock’s notch
with the indentation in the T- C l a m p .
h) Firmly tighten each memory lock’s bolt.
i ) Firmly tighten T-Clamp wing nuts labeled “tighten first.”
j ) Firmly tighten all remaining wing nuts.
DM Pro Kit Setup Guide 5