Instruction Manual

Table Of Contents

3 Installation

NOTE

When mounting the CM, it is important to achieve a solid mechanical connection between the equipment

and the CM in addition to any adapter if fitted, ideally mounted to a flat surface. The CM can be mounted on

surfaces up to 80° C (176° F).

3.1 General Guidelines

The general guidelines for custom fitting of the CM to rotating equipment, we recommend the

following.

CM screw Clearance hole Thread Tool Max torque

Button SHCS [Drill Size / Depth] [Tap Size / Depth] Hex key

M6 x 30mm 5mm / 10mm M6 / 7mm 4mm 10 Nm / 7.5 ft-lb

2067-0006

3.2 Alfa Laval equipment guidelines

For Alfa Laval equipment which does not have the specific M6 tapping available for retro-fit, an

adapter kit can be supplied.

Please find the relevant addendum for the specific Alfa Laval equipment.

200002050-2-EN-GB