User's Manual

January 13, 2009 / Version: 2.0 24

WPS

The primary goal of Wi-Fi Protected Setup (Wi-Fi Simple Configuration) is to simplify the security

setup and management of Wi-Fi networks. This adapter supports the configuration setup using

PIN configuration method or PBC configuration method through an internal or external Registrar.

Items Information

1. WPS AP List Display the information of surrounding APs with WPS IE from last scan

result. List information includes SSID, BSSID, Channel, ID (Device

Password ID), and Security-Enabled.

2. WPS Profile

List

Display all of credentials got from the Registrar. List information includes

SSID, MAC Address, Authentication and Encryption Type. If STA Enrollee,

credentials are created as soon as each WPS success. If STA Registrar,

Utility creates a new credential with WPA2-PSK/AES/64Hex-Key and

doesn't change until next switching to STA Registrar.

3. Rescan Click to rescan the wireless networks.

4. Information Display the information about WPS IE on the selected network. List

information includes Authentication Type, Encryption Type, Config

Methods, Device Password ID, Selected Registrar, State, Version, AP Setup

Locked, UUID-E and RF Bands.

5. Pin Code 8-digit numbers. It is required to enter PIN Code into Registrar using PIN

method. Each Network card has only one PIN Code of Enrollee. Click on the

Renew button to renew the PIN code.

6. Config Mode Enrollee or an external Registrar.

7. Detail Information about Security and Key in the credential.

8. Connect Command to connect to the selected network inside credentials.

9. Rotate Command to connect to the next network inside credentials.

10. Disconnect Stop WPS action and disconnect this active link. And then select the last

profile at the Profile Page of Utility if exists. If there is an empty profile

page, the driver will select any non-security AP.

11. Export Profile Click the "Export Profile" button will export the WPS profile.

12. Delete Delete an existing credential. And then select the next credential if exist. If

there is an empty credential, the driver will select any non-security AP.

13. PIN Start to add to Registrar using PIN configuration method.

14. PBC Start to add to AP using PBC configuration method.

15. WPS

associate IE

Send the association request with WPS IE during WPS setup. It is optional

for STA.

16. WPS probe IE Send the probe request with WPS IE during WPS setup. It is optional for

STA.

17. Auto Select the AP automatically.

18. Progress Bar Display rate of progress from Start to Connected status.

19. Status Bar Display currently WPS Status.