User's Manual
Table Of Contents
Glossary
single
radio
channel,
enabling
Virtual
AP
technology
to
optimize
the
use
of
limited
WLAN
radio
spectrum.
Wi-Fi Protected Access
WPA
employs
802.1X
as
its
basic
framework
for
user
authentication
and
dynamic
key
management
to
provide
an
enhanced
security
solution
for
802.11
wireless
networks.
Wired Equivalent Privacy (WEP)
WEP
is
based
on
the
use
of
security
keys
and
the
popular
RC4
encryption
algorithm.
Wireless
devices
without
a
valid
WEP
key
will
be
excluded
from
network
traffic.
WPA Pre-shared Key (WPA-PSK)
WPA-PSK
can
be
used
for
small
office
networks
with
a
limited
number
of
users
that
may
not
need
a
high
level
of
security.
WPA-PSK
provides
a
simple
security
implementation
that
uses
just
a
pre-shared
password
for
network
access.
Glossary-4
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one of the following measures: -Reorient or relocate the receiving
antenna. -Increase the separation between the equipment and receiver. -Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected. -Consult the dealer or an experienced radio/TV technician for help. This device complies with
Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause undesired operation.
You are cautioned that changes or modifications not expressly approved by the party responsible for compliance
could void your authority to operate the equipment.